Avenview HDM-SPLITPRO-4A Specifications download pdf (Page 15)

www.avenview.com

1.13 Software Operation

File

Connect

Synchronizes the status of the DVI-SPLITPRO-2B with that of the software, especially after

IR commands sent.

Save Settings

Save current user preferred settings such as the positions and sizes of the videos, the width

or color of border etc. into your favorite setting files. (See Figure Save Setting below)

Load Settings

Load the favorite settings from the previously saved file

IR Control

Enable or Disable IR Remote Control function

Auto Sleep

Enable or Disable auto sleep function if there is no video signal detected in the main

channel

Device ID

Define Device ID of each DVI-SPLITPRO-2B especially when multiple devices are cascaded.

(See Device ID Setting below)

Factor Reset

Restore all system settings to factory default

Exit

Quit the software

Save Setting

1. Assign an ID for the connect DVI-SPLITPRO-2B, Type a digit from 1 –

255 and then click on “Write”.

2. Read the ID of the connected DVI-SPLITPRO-2B; Click “Read” and the

Device ID will show up under “ID Number”.

3. Super Control: All devices cascaded will receive and respond the same

way when you are operating the Control Software.

4. Single Device Control: Remote the check beside the “Super Control”

and type a number that represent a specific DVI-SPLITPRO-2B and

then click “Apply. Exit the “Device ID Setting” and click “Connect”.

 *Please note that if only one device is being used, you don’t need to

change Device ID.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

No comments

Avenview HDM-SPLITPRO-4A Specifications Page 15